BENDABLE PLYWOOD
Wood species and compositions
This plywood, commercially named "Toro/Flexos" consists of a special composition which makes it possible to reach a shaped form with very low bending radius. The faces are made on exotic veneer (Ceiba) while the panel is realized with a bonding quality suitable for use in dry conditions. For exterior use, an Okoume' version is also available with adhesive adequate for humid conditions.

For specific application, where a decorative appearance is also required (for instance to realize a curve connection between wall and roof), the company can offer an ultra-thin plywood (with the thickness of 1,8 mm) made on three layers of sliced veneers.

It is finally available a special bendable panel composed with a decorative sliced veneer face and a series of parallel incisions in the backside (multi-cut) which can allow it to assume particular(and composed curved shape.
Main characteristics
  • limited density (EN 323): 410 kg/m3;
  • radius of curvature without showing big surface checks: 10 (9-12) times the panel's thickness..
Dimensions
The sizes shown below are the standard dimensions most commonly produced:
125 x 250/310 or 250/310 x 125 cm
while thickness ranges from 5 to 16 mm (6 mm only for the Okoume' version).
Use
Toro-flexos plywood is particularly suited for construction, covering of columns, arched windows, curve profiles for furnitures and offices, etc..

Bendable

Bendable multi-cut

Bendable multi-cut

BROWSE OUR BROCHURE

SELLING CONDITIONS
2009 powered by algatraz algatraz